ELCTRO STATIC PRECIPITATOR
Introduction: - it is the
device used for the removel of dust and ash particle carried with exhaust flue
gasses of thermal power plant. Performance: - The performance of the
precipitator depends on the physical & chemical properties of the gas and
particles treated. Its design and performance are strongly dependent on the
properties of the coal burnt in the furnace.
The fly ash from low sulpher coal has
electrical resistivity and is difficult to precipitate .Theory and experience
indicates that when the dust resistivity exceed a critical value 1010 Cm. the
precipitator operating voltage is limited which in turn reduces the
precipitator efficiency the less in performance increases quite rapidly for
resistivity greater than 1010 Cm and resistivity is there fore a major factor
in precipitator technology.
Parts of
E.S.P.:- there are mainly three parts of E.S.P.-
1.
Casing:- The outer structure of
E.S.P. on which all the parts of E.S.P. removal is called casing.
2.
Electrodes:- It is an important of
E.S.P. which precipitated the ashes and particles from the exhaust gases. It is
of two type.
a) Collecting electrodes b)
Emitting electrodes
a) Collecting electrodes:- It is a positively charged electrodes. The thickness and length of
the electrodes are made of steel sheet pressed to a special profile committing
to a special profile and to thin wire drawn to a helical from to a stretch
emitting stretching tool.
b) Emitting electrodes:- It is a negatively charge of electrodes. The number of electrodes
is three. In emitting electrodes 40 KV D.C. is supplied by rectified
transformers. Number of rectified transformers in E.S.P. is six. The distance
between one rows of collecting electrodes to another rows should be 300mm.
3. Electricity:-
WORKING PROCEDURE:- When a unidirectional high
voltage is applied to the three emitting electrodes and earthed the dust of the
flue gas from boiler passes between the row of collecting and emitting. The
high voltage induces the ionization of gas molecules adjacent to the –ve
electrodes and negative charge towards the collecting electrodes. On the way of
the collecting electrodes –ve charge get deposits. In the presence of the high
electric fields between the electrodes, the charges dust particle experiences a
force which causes the particle to attach through the collecting electrodes and
finally get deposited in hopper. A minor portion of the dust particle gets
deposited on emitting.
Comments
Post a Comment